Specifications

dot1x max-req
375
dot1x max-req
Specifies the maximum number of EAP-Request retransmissions if the supp-timeout value
is exceeded. If the number of retransmissions exceeds this value, authentication is
determined to have failed.
Syntax
To set or change information:
dot1x max-req <Counts>
To delete information:
no dot1x max-req
Input mode
(config-if)
Parameters
<Counts>
Specifies the maximum number of EAP-Request retransmissions.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 10 (times)
Default behavior
The maximum number of EAP-Request retransmissions is two.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command takes effect only if the
dot1x port-control command has been set.
Related commands
dot1x system-auth-control
dot1x timeout supp-timeout
dot1x port-control