Specifications

dot1x ignore-eapol-start
374
dot1x ignore-eapol-start
Sets the Switch not to issue EAP-Request/Identity packets in response to EAPOL-Start
from a supplicant.
Syntax
To set information:
dot1x ignore-eapol-start
To delete information:
no dot1x ignore-eapol-start
Input mode
(config-if)
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command takes effect only if the
dot1x port-control command has been set.
4. This command can be set only on an interface on which the
dot1x
reauthentication command has been set and the dot1x supplicant-detection
command without the
disable parameter set has been set.
5. This command cannot be set on an interface on which the
dot1x
supplicant-detection command with the disable parameter set has been set.
6. If this command has been set, you cannot use the
no dot1x reauthentication
command to set no re-authentication.
Related commands
dot1x reauthentication
dot1x supplicant-detection
dot1x system-auth-control
dot1x port-control