Specifications

dot1x force-authorized eapol
370
dot1x force-authorized eapol
Sends according to the IEEE 802.1X forced authentication settings the EAPOL-Success
response packet from the Switch to the terminal to be authenticated when its status has
been forcibly changed to authentication authorized.
Syntax
To set information:
dot1x force-authorized eapol
To delete information:
no dot1x force-authorized eapol
Input mode
(config)
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. This command affects operation when forced authentication is authorized by setting
of the following commands:
 Port-based authentication (static):
dot1x force-authorized or
authentication force-authorized enable
 Port-based authentication (dynamic), VLAN-based authentication (dynamic):
dot1x force-authorized vlan or authentication force-authorized
enable
Related commands
dot1x force-authorized
dot1x force-authorized vlan
authentication force-authorized enable
authentication force-authorized vlan