Specifications

dot1x force-authorized
368
dot1x force-authorized
When the RADIUS authentication method is used, this command forcibly changes the
status of a terminal that requests authentication on the applicable port to authentication
authorized if the RADIUS server does not respond or a request to the RADIUS server fails
because of a route failure or other problem.
Syntax
To set information:
dot1x force-authorized
To delete information:
no dot1x force-authorized
Input mode
(config-if)
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. Be especially careful when using this functionality, as it can pose a security problem.
4. This command takes effect when the following condition is met:
All the following configurations have been set:
- dot1x system-auth-control
-
radius-server host or dot1x radius-server host
-
dot1x force-authorized
#1
-
dot1x port-control auto
#1
-
switchport mode access
#1
-
aaa authentication dot1x
#2
-
dot1x authentication
#3
#1
Set for the same interface.
- The following accounting log data is collected when an authentication