Specifications

dot1x auto-logout
367
dot1x auto-logout
The no dot1x auto-logout command disables the setting to automatically cancel
authentication when no frame is received from a terminal authenticated by IEEE 802.1X for
a certain period of time.
Syntax
To set information:
no dot1x auto-logout
To delete information:
dot1x auto-logout
Input mode
(config)
Parameters
None
Default behavior
Authentication is automatically canceled if no frames are received from a terminal
authenticated by IEEE 802.1X for a certain period of time.
Impact on communication
After the no dot1x auto-logout command is set, authentication is not automatically
canceled if no frames are received from a terminal authenticated by IEEE 802.1X for a
certain period of time.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
Related commands
dot1x port-control
dot1x system-auth-control
mac-address-table aging-time