Specifications

aaa authentication dot1x
363
Default behavior
None
Impact on communication
If the setting of this command is changed, the Switch clears the authentication status of the
affected terminals.
 When the Switch default is added, authentication is not canceled.
 When the Switch default is changed or deleted, authentication of the terminals
authenticated by using the Switch default is canceled.
 When an authentication method list is added, authentication of terminals on ports
specifying the corresponding authentication method list name is canceled. (If the
authentication method list set for the port is not set by this command, the Switch is
authenticated by the Switch default.)
 When the authentication method list is changed or deleted, authentication of
terminals authenticated by the corresponding authentication method list is canceled.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All IEEE 802.1X settings take effect when the dot1x system-auth-control
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. If this command is not set, the RADIUS server cannot be used for IEEE 802.1X
authentication.
Related commands
aaa authorization network
aaa group server radius
dot1x authentication
dot1x system-auth-control
radius-server host or dot1x radius-server host