Specifications

transport input
12
transport input
Restricts access from remote operation terminals based on protocol.
Syntax
To set or change information:
transport input {telnet | all | none}
To delete information:
no transport input
Input mode
(config-line)
Parameters
{telnet | all | none}
telnet
Accepts remote access that uses the Telnet protocol.
all
Accepts remote access using any protocol (currently only Telnet is supported).
none
Does not accept remote access using any protocol.
1. Default value when this parameter is omitted:
all (Accepts remote access that uses the Telnet protocol.)
2. Range of values:
telnet, all, or none.
Default behavior
Accepts remote access that uses the Telnet protocol.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. To permit or restrict FTP connections, use the ftp-server command in config
mode.
Related commands
line vty
ftp-server
ip access-group