Specifications

control-packet user-priority
347
control-packet user-priority
Specifies the user priority in the VLAN tags of frames spontaneously sent by a Switch. If
this command is not set or if information is deleted, 7 is used as the user priority of frames
spontaneously sent.
Syntax
To set or change information:
control-packet user-priority { layer-2 <User-priority> | layer-3
<User-priority> | layer-2 <User-priority> layer-3 <User-priority> }
To delete information:
no control-packet user-priority
Input mode
(config)
Parameters
{ layer-2 <User-priority> | layer-3 <User-priority> | layer-2 <User-priority> layer-3
<User-priority> }
Specifies the user priority of frames spontaneously sent by a Switch.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify 0 to 7. 7 is set as the user priority for parameters that are not set.
Default behavior
7 is used as the user priority of frames spontaneously sent by a Switch.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
None