Specifications

traffic-shape rate
345
traffic-shape rate
Sets the bandwidth by setting port bandwidth control for an interface (physical port) to limit
the send bandwidth.
Syntax
To set or change information:
traffic-shape rate { <kbit/s> | <Mbit/s>M }
To delete information:
no traffic-shape rate
Input mode
(config-if)
Parameters
rate { <kbit/s> | <Mbit/s>M }
Sets port bandwidth control. Using this functionality limits the total-line send
bandwidth to the specified bandwidth.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
See the table below.
You can specify k (default) or M for the unit of the value.
Set the bandwidth so that it is equal to or smaller than the line speed.
Table 20-12 Setting range for port bandwidth control
Setting unit
#1
Setting range Increment
Mbit/s 1 M to 1000 M 1 Mbit/s
kbit/s 1000 to 1000000 100 kbit/s
#2
64 to 960 64 kbit/s
#3
#1: 1M is treated as 1000000, and 1k is treated as 1000.
#2: When setting a value of 1000 kbit/s or more, specify the value in 100 kbit/s increments
(1000, 1100, 1200...10000000).
#3: When setting a value less than 1000 kbit/s, specify the value in 64 kbit/s increments (64,
128, 192...960).
Default behavior
The send bandwidth is not limited.
Impact on communication
None