Specifications

qos-queue-list
343
2. Range of values:
<Packet>: 1 to 15
Default behavior
None
Impact on communication
If the scheduling mode is changed by specifying a QoS queue list name for the
qos-queue-group command and queued packets remain in the send queue of the
applicable line, all packets are cleared.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If the scheduling mode is changed by specifying a QoS queue list name for the
qos-queue-group command and queued packets remain in the send queue of the
changed interface, all packets are cleared. While packets are being cleared, no new
packets can be queued. You need to be careful if you logged in via a network.
2. WFQ does not work correctly when the line status is half duplex mode. Change to
full-duplex mode.
3. If WFQ is set, there might be a maximum error of 10% between the set minimum
bandwidth and the actual value.
4. To use port bandwidth control and scheduling of QoS queue list information at the
same time, set PQ as the scheduling mode.
5. If
wfq is selected as the scheduling mode, <Min rate> must be set for the queues that
will be used.
6. When the bandwidth is set in Mbit/s (<Mbit/s>
M), the value is displayed in kbit/s for
show running-config and show startup-config.
Related commands
qos-queue-group