Specifications

qos-queue-group
340
qos-queue-group
Sets QoS queue list information for an interface (physical port).
Syntax
To set information:
qos-queue-group <QoS queue list name>
To delete information:
no qos-queue-group
Input mode
(config-if)
Parameters
<QoS queue list name>
Specifies the QoS queue list name.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
This name can be 3 to 31 characters. For details about the characters that can
be specified, see Specifiable values for parameters.
Default behavior
PQ is set as the scheduling mode.
Impact on communication
If the scheduling mode is changed by specifying a QoS queue list name and queued
packets remain in the send queue of the applicable line, all packets are cleared.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If the scheduling mode is changed by specifying a QoS queue list name and queued
packets remain in the send queue of the changed interface, all packets are cleared.
While packets are being cleared, no new packets can be queued. You need to be
careful if you logged in via a network.
2. If you did not set the scheduling mode by specifying the QoS queue list name, PQ is
used as the scheduling mode.
3. If an invalid queue list name is specified by using the
qos-queue-group command,
PQ is used as the scheduling mode.
Related commands
qos-queue-list
interface fastethernet
interface gigabitethernet