Specifications

qos (mac qos-flow-list)
339
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If nnnn.nnnn.nnnn ffff.ffff.ffff is entered as the source address and the
destination address,
any is displayed.
2. If a protocol name is set for the destination address or if the address of a protocol
name that can be set is set, the protocol name is displayed. For details about the
address of a protocol name that can be set as the destination address, see Table
20-8 Destination MAC address names that can be specified . If nnnn
.nnnn.nnnn
0000.0000.0000 is entered as the source address and the destination address in
cases other than the above,
host nnnn.nnnn.nnnn is displayed.
3. When
cos and replace-user-priority are set for the action parameter at the
same time, the user priority is replaced with the value set for
cos.
4. The parameters set by using this command are valid only for relay packets.
Therefore, the set parameters are not valid for incoming and outgoing packets.
Related commands
mac qos-flow-list
mac qos-flow-group
mac qos-flow-list resequence
remark