Specifications

ftp-server
10
ftp-server
Permits access from remote operation terminals by using FTP. To set the IPv4 address of a
remote operation terminal to permit or deny logging in to a Switch, set a common access
list that is shared by Telnet access in config-line mode.
Syntax
To set information:
ftp-server
To delete information:
no ftp-server
Input mode
(config)
Parameters
None
Default behavior
Does not allow remote FTP access.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
When an access list has been configured in config-line mode, the IPv4 addresses of
remote operation terminals for which logging in to a Switch using FTP is permitted or
denied are restricted according to the same access list.
Related commands
line vty
ip access-group