Specifications

mac qos-flow-group
325
mac qos-flow-group
Enables the QoS functionality by applying a MAC QoS flow list to an Ethernet interface or a
VLAN interface.
Syntax
To set information:
mac qos-flow-group <QoS flow list name> in
To delete information:
no mac qos-flow-group <QoS flow list name> in
Input mode
(config-if)
Parameters
<QoS flow list name>
Specifies the MAC QoS flow list name.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
This name can be 3 to 31 characters. For details about the characters that can
be specified, see Specifiable values for parameters.
in
Specifies
Inbound.
in: Inbound (Specifies the receiving side)
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. This command cannot be set if qos is not set when the system function command
has been set. (This command can be set if the
system function command has not
been set.) [AX1250S] [AX1240S]
2. One MAC QoS flow list can be set for one interface. A maximum of 64 flow listscan
be applied to an Ethernet interface or a VLAN interface.
3. If a non-existent MAC QoS flow list name is set, no operation is performed. The MAC