Specifications

ip qos-flow-group
318
ip qos-flow-group
Enables the QoS functionality by applying an IPv4 QoS flow list to an Ethernet interface or
a VLAN interface.
Syntax
To set information:
ip qos-flow-group <QoS flow list name> in
To delete information:
no ip qos-flow-group <QoS flow list name> in
Input mode
(config-if)
Parameters
<QoS flow list name>
Specifies the IPv4 QoS flow list name.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
This name can be 3 to 31 characters. For details about the characters that can
be specified, see Specifiable values for parameters.
in
Specifies
Inbound.
in: Inbound (Specifies the receiving side)
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. This command cannot be set if qos is not set when the system function command
has been set. (This command can be set if the
system function command has not
been set.) [AX1250S] [AX1240S]
2. One IPv4 QoS flow list can be set for one interface. A maximum of 64 flow listscan be
applied to an Ethernet interface or a VLAN interface.
3. If you specify a non-existent IPv4 QoS flow list name, this will be ignored. The IPv4