Specifications

permit (mac access-list extended)
309
None. (The parameter is not set as a detection condition.)
2. Range of values:
See Specifiable values for parameters.
user-priority <Priority>
Specifies the user priority.
1. Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2. Range of values:
Specify 0 to 7 in decimal.
Default behavior
None
Impact on communication
If any entry is added when an access list with no entries set is being applied to an interface,
all packets received on the applicable interface are discarded temporarily until the entry is
applied to the interface.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If nnnn.nnnn.nnnn ffff.ffff.ffff is entered as the source address and the
destination address,
any is displayed.
2. If a protocol name is set for the destination address or if the address of a protocol
name that can be set is set, the protocol name is displayed. For details about the
address of a protocol name that can be set as the destination address, see Table
19-8 Destination MAC address names that can be specified. If nnnn
.nnnn.nnnn
0000.0000.0000
is entered as the source address and the destination address in
cases other than the above,
host nnnn.nnnn.nnnn is displayed.
Related commands
mac access-group
mac access-list resequence
deny (mac access-list extended)
remark