Specifications

mac access-list resequence
297
mac access-list resequence
Re-sequences the sequence numbers that determine the order in which the MAC filter
applies filter conditions.
Syntax
To set or change information:
mac access-list resequence <ACL ID> [<Starting Seq> [<Increment Seq>]]
Input mode
(config)
Parameters
<ACL ID>
Specifies the identifier of the MAC filter that is to be set.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify an access list name that is 3 to 31 characters. For details about the
characters that can be specified, see Specifiable values for parameters.
<Starting-Seq>
Specifies the starting sequence number.
1. Default value when this parameter is omitted:
The initial value is 10.
2. Range of values:
Specify 1 to 4294967295 (in decimal).
<Increment-Seq>
Specifies the increment value for the sequence.
1. Default value when this parameter is omitted:
The initial value is 10.
2. Range of values:
Specify 1 to 100 in decimal.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None