Specifications

flow detection mode
264
flow detection mode
Sets the flow detection mode for the filtering and QoS functionality.
This command changes the allocation pattern for the maximum number of entries in a
hardware table.
By changing the allocation pattern according to the operating mode, you can concentrate
hardware resources on the necessary tables for use.
This command is used to set the basic operating conditions for hardware. If you want to
change the allocation pattern, you must delete the
ip access-group, mac access-group,
ip qos-flow-group, and mac qos-flow-group commands if they have been set.
Accordingly, you must set this command during the first step of actual operation. We
recommend that you do not make any changes during operation.
If you do not set this command or if the information has been deleted,
layer2-2 returns to
its default state.
Syntax
To set or change information:
flow detection mode {layer2-1 | layer2-2}
To delete information:
no flow detection mode
Input mode
(config)
Parameters
{layer2-1 | layer2-2}
Sets the flow detection mode.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
None
The following table describes the commands applicable to the flow detection modes.
Table 18-1 Commands applicable to flow detection mode
Applicable command
mac ip
Flow detection mode access-group access-group
qos-flow-group qos-flow-group
Layer 2-1 Y N
Layer 2-2 N Y
Legend Y: Can be set; N: Cannot be set