Specifications

ipv6 mld snooping mrouter
253
ipv6 mld snooping mrouter
Sets a multicast router port for the VLAN interface.
Syntax
To set or change information:
ipv6 mld snooping mrouter interface {gigabitethernet <IF#> |
port-channel <Channel group#>} [AX2200S]
ipv6 mld snooping mrouter interface {fastethernet <IF#> |
gigabitethernet <IF#> | port-channel <Channel group#>} [AX1250S]
[AX1240S]
To delete information:
no ipv6 mld snooping mrouter interface {gigabitethernet <IF#> |
port-channel
<Channel group#>} [AX2200S]
no ipv6 mld snooping mrouter interface {fastethernet <IF#> |
gigabitethernet <IF#> | port-channel <Channel group#>} [AX1250S]
[AX1240S]
Input mode
(config-if)
Parameters
{gigabitethernet <IF#> | port-channel <Channel group#>} [AX2200S]
{fastethernet <IF#> | gigabitethernet <IF#> | port-channel <Channel group#>}
[AX1250S] [AX1240S]
Sets an interface for a multicast router port that has been set.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
<IF#>: Specify an interface port number belonging to the VLAN.
<Channel group#>: Specify a channel group number belonging to the VLAN.
For details about the specifiable values, see Specifiable values for
parameters.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after the setting value is changed.
Notes
1. If ipv6 mld snooping is not set for the applicable interface, this functionality does
not operate.
2. To connect a Switch to a multicast router port, enable the MLD snooping functionality
on the destination Switch.