Specifications

ipv6 mld snooping source
252
ipv6 mld snooping source
Sets the source IPv6 address of the MLD snooping functionality to be used on a VLAN
interface.
Syntax
To set or change information:
ipv6 mld snooping source <IPv6 address>
To delete information:
no ipv6 mld snooping source
Input mode
(config-if)
Parameters
<IPv6 address>
Sets the source IPv6 address for the MLD snooping functionality.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
The IPv6 link-local address is set in colon notation.
Default behavior
The MLD querier functionality does not operate.
Impact on communication
None
When the change is applied
The change is applied immediately after the setting value is changed.
Notes
1. If ipv6 mld snooping or the ipv6 mld snooping source command is not set for the
applicable interface, the MLD querier functionality does not operate.
2. This command cannot be set iff multiple interfaces (interface range) are set.
3. Specify the IPv6 link-local address. If the IPv6 global address is specified, a Switch
might not operate as a system.
Related commands
ipv6 mld snooping
ipv6 mld snooping querier