Specifications

ip igmp snooping mrouter
246
ip igmp snooping mrouter
Sets a multicast router port for the VLAN interface.
Syntax
To set or change information:
ip igmp snooping mrouter interface {gigabitethernet <IF#> | port-channel
<Channel group#>} [AX2200S]
ip igmp snooping mrouter interface {fastethernet <IF#> | gigabitethernet
<IF#> | port-channel <Channel group#>} [AX1250S] [AX1240S]
To delete information:
no ip igmp snooping mrouter interface {gigabitethernet <IF#> |
port-channel <Channel group#>} [AX2200S]
no ip igmp snooping mrouter interface {fastethernet <IF#> |
gigabitethernet <IF#> | port-channel <Channel group#>} [AX1250S]
[AX1240S]
Input mode
(config-if)
Parameters
{gigabitethernet <IF#> | port-channel <Channel group#>} [AX2200S]
{fastethernet <IF#> | gigabitethernet <IF#> | port-channel <Channel group#>}
[AX1250S] [AX1240S]
Sets an interface for a multicast router port that has been set.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
<IF#>: Specify an interface port number belonging to the VLAN.
<Channel group#>: Specify a channel group number belonging to the VLAN.
For details about the specifiable values, see Specifiable values for
parameters.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after the setting value is changed.
Notes
1. If ip igmp snooping is not set for the applicable interface, this functionality does not
operate.
2. To connect a Switch to a multicast router port, enable the IGMP snooping
functionality on the destination Switch.
3. If you specify a port number belonging to a port channel for a multicast router port, no