Specifications
ip arp inspection trust
223
ip arp inspection trust
Sets the applicable interface as a trusted port where no dynamic ARP inspection is
performed when the DHCP snooping functionality is enabled on a Switch.
Syntax
To set information:
ip arp inspection trust
To delete information:
no ip arp inspection trust
Input mode
(config-if)
Parameters
None
Default behavior
Dynamic ARP inspection is performed.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. On an interface on which this command is set, even if the interface is accommodated
in the VLAN where the dynamic ARP inspection functionality is enabled, the
inspection is not performed.
2. The ARP packet reception rate of the interface on which this command is set has no
limit.
Related commands
ip dhcp snooping
ip dhcp snooping vlan