Specifications

vlan-group
219
vlan-group
Sets the VLAN group that will be used for the Ring Protocol and the mapping IDs of the
VLANs participating in the VLAN group.
A maximum of two VLAN groups can be set for the ring.
Syntax
To set or change information:
vlan-group <Group ID> vlan-mapping <Mapping ID list>
To delete information:
no vlan-group <Group ID>
Input mode
(config-axrp)
Parameters
<Group ID>
Specifies the VLAN group ID that will be used for the Ring Protocol.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 2
vlan-mapping <Mapping ID list>
Specifies the mapping IDs of the VLANs participating in a VLAN group. One VLAN
mapping ID can be set. Use hyphens (
-) or commas (,) to specify multiple VLAN
mapping IDs at the same time.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 128
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If the same VLAN mapping is assigned to VLAN groups in different rings, these rings
cannot share the same port as a ring port. Note, however, that it is possible to specify
the same ring port if the port is a shared link (ring port for which
shared is set).
Related commands
axrp vlan-mapping