Specifications

multi-fault-detection vlan
217
multi-fault-detection vlan
Sets the VLAN for multi-fault monitoring. The VLAN specified by this command forwards
control frames used for monitoring multiple faults.
Set this command for shared link monitoring rings in a multi-ring configuration with shared
links.
Syntax
To set information:
multi-fault-detection vlan <vlan id>
To delete information:
no multi-fault-detection vlan
Input mode
(config-axrp)
Parameters
<vlan id>
Transfers multi-fault monitoring frames. Multi-fault monitoring is not performed.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
See Specifiable values for parameters. Note that the default VLAN (VLAN ID
= 1) cannot be specified for this parameter.
Default behavior
None
Impact on communication
None
When the change is applied:
The change is applied immediately after setting values are changed.
Notes
1. You cannot specify a VLAN that is used as a multi-fault control VLAN by another ring
ID.
2. For the multi-fault control VLAN, you cannot specify a VLAN that is used as a control
VLAN.
3. You cannot specify a VLAN that is used in a VLAN mapping.
Related commands
None