Specifications

forwarding-shift-time
214
forwarding-shift-time
Sets the reception hold time for flush control frames in transit node.
When the reception hold time passes, if no flush control frames are received, the status of a
ring port changes from
Blocking to Forwarding.
Syntax
To set information:
forwarding-shift-time {<Seconds> | infinity}
To delete information:
no forwarding-shift-time
Input mode
(config-axrp)
Parameters
{<Seconds> | infinity}
Specifies the hold time in seconds until a flush control frame is received.
If you set
infinity, there is no limit on the hold time, and the status of the ring port
on the transit node does not switch to
Forwarding until a flush control frame is
received.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 65535 (seconds) or
infinity
Default behavior
10 seconds is used as the reception hold time for flush control frames.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If the sending interval for health check frames on the master node is longer than the
reception hold time for flush control frames on the transit node, the status of the ring
port on the transit node switches to
Forwarding before the master node detects
normal status. This could produce a temporary loop.
Set the hold time value based on the interval at which health check frames are sent
from the master node.
Related commands
None