Specifications

control-vlan

212

When the change is applied

The change is applied immediately after setting values are changed.

Notes

1. You cannot specify a VLAN that is used as a control VLAN by another ring ID.

2. You cannot specify a VLAN that is used in a VLAN group.

3. For the control VLAN, you cannot specify a VLAN that is being used by the multi-fault

monitoring VLAN.

4. While the Ring Protocol is operating, if you change or delete the control VLAN, this

functionality is temporarily disabled. As a result, a loop might occur depending on the

network configuration (ring configuration) to which the functionality is applied. To

avoid a loop, before entering this command, place the interface that is the ring port in

the shutdown state.

forwarding-delay-time operates when the following occurs:

 The Switch is started (includes execution of the

reload or ppupdate operation

command).

Related commands

vlan