Specifications

control-vlan
211
control-vlan
Sets the VLAN to be used as a control VLAN. You can use the VLANs set by using this
command to send and receive control frames that monitor the ring status.
Specifying the
forwarding-delay-time parameter allows you to set the time required to
change the status of the control VLAN to
Forwarding during initial operation. You can
therefore adjust the time required before starting to monitor the status of received flush
control frames on the transit node, to ensure that flush control frames sent by the master
node are received.
Syntax
To set information:
control-vlan <VLAN ID> [forwarding-delay-time <Seconds>]
To delete information:
no control-vlan
Input mode
(config-axrp)
Parameters
<VLAN ID>
Specifies the VLAN to be used as the control VLAN.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
See Specifiable values for parameters.
Note that the default VLAN (VLAN ID = 1) cannot be specified for this
command.
forwarding-delay-time <Seconds>
Sets the time (in seconds) required before the control VLAN switches to
Forwarding
when a Switch is started in transit node.
1. Default value when this parameter is omitted:
The control VLAN transitions to
Forwarding immediately after the ring port
comes up.
2. Range of values:
1 to 65535 (seconds)
3. Note on using this parameter:
To delete only this parameter, set
control-vlan again with this parameter
omitted. This operation is used to delete parameters.
Default behavior
None
Impact on communication
None