Specifications

axrp-ring-port
209
axrp-ring-port
Sets an interface that operates as the ring port for the Ring Protocol. The interfaces that
can be set are Ethernet interfaces and port channel interfaces.
Syntax
To set information:
axrp-ring-port <Ring ID> [shared]
To delete information:
no axrp-ring-port <Ring ID>
Input mode
(config-if)
Parameters
<Ring ID>
Sets the ring ID.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 65535
shared
When a Switch operates as a transit node on a shared link, this parameter specifies
the ring port that will be the shared link.
Two ports must be specified to correspond with the ring ID.
1. Default value when this parameter is omitted:
The interface operates as a standard ring port.
2. Range of values:
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. Two ring ports can be specified as corresponding to one ring ID.
2. You cannot specify an Ethernet interface that is part of a channel group as a ring port.
Conversely, an Ethernet interface that is specified as a ring port cannot be part of a
channel group. Set the ring port as the port channel interface to which the applicable
Ethernet interface belongs.