Specifications

spanning-tree single port-priority
188
spanning-tree single port-priority
Sets the priority for applicable Single Spanning Tree ports.
Syntax
To set or change information:
spanning-tree single port-priority <Priority>
To delete information:
no spanning-tree single port-priority
Input mode
(config-if)
Parameters
<Priority>
Sets the port priority. Use a multiple of 16 as the port priority. The lower the value, the
higher the priority.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0 to 240
3. Note on using this parameter:
Changing the port priority might change the topology.
Default behavior
The setting of the spanning-tree port-priority command is used. If the
spanning-tree port-priority command has not been set, the port priority is set to 128.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
None