Specifications

spanning-tree single mode
185
spanning-tree single mode
Sets the operating mode of Single Spanning Tree.
Syntax
To set or change information:
spanning-tree single mode { stp | rapid-stp }
To delete information:
no spanning-tree single mode
Input mode
(config)
Parameters
{ stp | rapid-stp }
Sets the protocol to be used. If the protocol is changed during Spanning Tree
operation, the Spanning Tree Protocol is re-initialized. If
stp is set, Spanning Tree
mode is used. If
rapid-stp is set, rapid Spanning Tree mode is used.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
stp or rapid-stp
Default behavior
stp is set for the Single Spanning Tree operating mode.
Impact on communication
If the spanning-tree single command is set, communications are interrupted until
recalculation of the topology is complete.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
None