Specifications

spanning-tree single hello-time
183
spanning-tree single hello-time
Sets the interval for sending Single Spanning Tree BPDUs.
Syntax
To set or change information:
spanning-tree single hello-time <Hello time>
To delete information:
no spanning-tree single hello-time
Input mode
(config)
Parameters
<Hello time>
Specifies the interval in seconds for sending BPDUs that are sent regularly from the
Switch.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 10 (seconds)
3. Note on using this parameter:
If you set 1 then this might result in a changeable topology.
Default behavior
2 seconds is set as the interval for sending BPDUs.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
None