Specifications

spanning-tree single cost
181
spanning-tree single cost
Sets the path cost for the applicable Single Spanning Tree ports.
Syntax
To set or change information:
spanning-tree single cost <Cost>
To delete information:
no spanning-tree single cost
Input mode
(config-if)
Parameters
<Cost>
Specifies the path cost value. The lower the <Cost> value, the higher the possibility
that the port will be used for forwarding the applicable frames.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
When
short is set by the spanning-tree pathcost method or the
spanning-tree single pathcost method command:
1 to 65535
When
long is set by the spanning-tree pathcost method or the
spanning-tree single pathcost method command:
1 to 200000000
3. Note on using this parameter:
Changing the path cost value might change the topology.
Default behavior
The path cost is applied according to the setting of the spanning-tree single pathcost
method command.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
spanning-tree cost
spanning-tree pathcost method
spanning-tree single pathcost method