Specifications

spanning-tree portfast default
179
spanning-tree portfast default
Sets the PortFast functionality to be used by default. This command is valid on the access,
protocol, and MAC ports of PVST+, Single Spanning Tree, and Multiple Spanning Tree.
Syntax
To set information:
spanning-tree portfast default
To delete information:
no spanning-tree portfast default
Input mode
(config)
Parameters
None
Default behavior
If the spanning-tree portfast command has been set, that setting is used. If the
spanning-tree portfast command has not been set, the spanning-tree portfast
default command does not operate.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
spanning-tree portfast