Specifications

vlan
144
- You cannot specify this parameter for VLANs you have already created as
port VLANs and MAC VLANs.
mac-based
Set this parameter for MAC VLANs.
1. Default value when this parameter is omitted:
The VLANs become port-based VLANs.
2. Note on using this parameter:
- When configuring MAC VLANs, you must set
mac-based.
- You cannot specify this parameter for VLANs you have already created as
port VLANs and protocol VLANs.
Default behavior
No VLANs are configured.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. There is always a default VLAN (VLAN ID = 1). The configuration items for the
default VLAN are different from those of other normal VLANs.
2. If you set a list by using <VLAN ID list>, you can configure multiple VLANs at one
time. Note, however, that under some conditions (multi-command mode) lists cannot
be set for some commands. For details, see the following table.
# Command Available in multi-command mode
1 state {suspend | active} Y
2 name N
3 protocol Y
4 mac-address N
Legend Y: Can be used; N: Cannot be used
3. The default VLAN setting (
VLAN ID=1) always exists in the configuration file and
cannot be deleted. The initial state of the default VLAN is for all ports to be available
as access ports.
4. The table below explains parameter items that can be set for the default VLAN, and
behavior specific to the default VLAN.