Specifications

state
130
state
Sets the VLAN status.
Syntax
To set or change information:
state {suspend | active}
To delete information:
no state
Input mode
(config-vlan)
Parameters
{suspend | active}
suspend
Disables the VLAN status and stops the sending and receiving of all frames on
the VLAN.
active
Sets the VLAN status to
enable and starts the sending and receiving of all
frames.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
suspend or active
Default behavior
The VLAN status is enable.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
When Set of ifAdminStatus is executed by the SetRequest operation of SNMP from the
SNMP manager, the setting is applied to this command.
Related commands
None