Specifications

protocol
129
protocol
Sets the protocol for identifying VLANs in protocol VLANs.
Syntax
To set or change information:
protocol <Protocol name>
To delete information:
no protocol <Protocol name>
Input mode
(config-vlan)
Parameters
<Protocol name>
Sets the protocol name of a protocol VLAN. This command can be set only when the
applicable VLAN is a protocol VLAN. If you want to use multiple protocol names for
a single VLAN, set the command separately for each protocol name used.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Protocol name set by the
vlan-protocol command.
Default behavior
No protocol is set.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. To use a protocol VLAN with an IPv4 address or IPv6 address set, you must use this
command to specify the applicable protocol.
Related commands
vlan-protocol