Specifications

name
128
name
Sets a VLAN name.
Syntax
To set or change information:
name <String>
To delete information:
no name
Input mode
(config-vlan)
Parameters
<String>
Sets a VLAN name.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify a character string that is no more than 32 characters. For details about
the characters that can be specified, see Specifiable values for parameters.
This parameter cannot be specified if <VLAN ID list> has been set by using
the
vlan command.
Default behavior
The initial value is VLANxxxx. Note that xxxx is a four-digit numeric string, including any
leading zeros, that indicates a VLAN ID.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. Note the following when using a VLAN name configured by using this command as a
VLAN after RADIUS authentication:
Specify a unique VLAN name. If the same VLAN name is used for two or more
VLANs, the smallest VLAN ID is allocated as the post-authentication VLAN in
RADIUS authentication mode.
Do not specify a number at the beginning of the VLAN name. A number at the
beginning will be recognized as the VLAN ID, which might result in an
authentication failure.
Related commands
None