Specifications

mac-address
127
mac-address
Sets the MAC address used to identify a MAC VLAN.
Syntax
To set or change information:
mac-address <MAC>
To delete information:
no mac-address <MAC>
Input mode
(config-vlan) (MAC VLAN only)
Parameters
<MAC>
Sets the MAC address that will be set for the MAC VLAN. This command can be set
only when the applicable VLAN is a MAC VLAN.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0000.0000.0000 to feff.ffff.ffff
The lowest bit of the first byte (the multicast bit) must not be 1.
Default behavior
The MAC address is not set.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. A MAC address that has been assigned to another VLAN cannot be set. Delete the
address, and then set it again.
2. If a MAC address dynamically configured by using the Layer 2 authentication
functionality has been set, the Layer 2 authentication settings are disabled, and the
mac-address settings take effect.
3. The number of MAC addresses that can be set for a Switch is 64.
Related commands
None