Specifications

mac-address-table static
121
mac-address-table static
Sets static MAC address table information.
Syntax
To set or change information:
mac-address-table static <MAC> vlan <VLAN ID> interface
{gigabitethernet <IF#> | port-channel <Channel group#> } [AX2200S]
mac-address-table static <MAC> vlan <VLAN ID> interface {fastethernet
<IF#> | gigabitethernet <IF#> | port-channel <Channel group#> } [AX1250S]
[AX1240S]
To delete information:
no mac-address-table static <MAC> vlan <VLAN ID>
Input mode
(config)
Parameters
<MAC>
Sets the MAC address to be registered as a static entry.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0000.0000.0000 to feff.ffff.ffff
Note, however, that a multicast MAC address (address whose lowest bit of the
first-byte is set to 1) cannot be set.
vlan <VLAN ID>
Sets the VLAN ID of the VLAN for static entries.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
See Specifiable values for parameters.
interface { gigabitethernet <IF#> | port-channel <Channel group#> } [AX2200S]
interface { fastethernet <IF#> | gigabitethernet <IF#> | port-channel <Channel
group#>
} [AX1250S] [AX1240S]
Sets the output destination interface for static entries. A physical port or link
aggregation can be set for the interface.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
<IF#>: See Specifiable values for parameters.
<Channel group#>: See Specifiable values for parameters.
Default behavior
No static entries are set.