Specifications

lacp system-priority
116
lacp system-priority
Sets the effective LACP system priority for a Switch.
Syntax
To set or change information:
lacp system-priority <Priority>
To delete information:
no lacp system-priority
Input mode
(config)
Parameters
<Priority>
Sets the LACP system priority. The lower the value, the higher the priority.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 65535
Default behavior
If the channel-group lacp system-priority command has been set, that setting is used.
If the
channel-group lacp system-priority command has not been set, 128 is used.
Impact on communication
If a priority is set for the operating channel group, the channel group goes down, and then
restarts.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. This command is effective only when LACP-based link aggregation is used.
2. If the LACP system priority is changed, the status of all ports registered for the
channel group changes to
Blocking (communication interrupted).
Related commands
None