Specifications

lacp port-priority
114
lacp port-priority
Sets the port priority.
Syntax
To set or change information:
lacp port-priority <Priority>
To delete information:
no lacp port-priority
Input mode
(config-if)
Parameters
<Priority>
Sets the port priority. The lower the value, the higher the priority.
When
on is set for the channel-group mode command
This parameter is used with the
max-active-port command to select the
standby links.
When
active or passive is set for the channel-group mode command
This parameter applies to port priority for the LACP protocol.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0 to 65535
Default behavior
128 is set as the port priority.
Impact on communication
If you set the port priority for the operating port by setting channel-group mode to active
or
passive, communication is temporarily interrupted. If you set the port priority for the
operating port by setting
channel-group mode to on, the port in use is changed by the
standby link functionality, and communication might temporarily stop.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If you set the max-active-port command, match its setting to the setting of
max-active-port for the destination device.
2. If you change <Priority>, the status of the applicable port changes to
Blocking
(communication interrupted).
Related commands
interface fastethernet
interface gigabitethernet