Specifications

channel-group mode
110
Notes
1. To change static link aggregation to LACP-based link aggregation, or vice versa,
delete this command, change the mode, and then set the command again.
2. When
channel-group mode is set, the port-channel setting of the specified
channel group is automatically generated. If
port-channel has already been set, no
specific operation is required.
3. If the
port-channel setting of the specified channel group number already exists
when you set this command, you must either specify the same setting for the
applicable interface and the port channel interface with the specified channel group
number or else not set a common configuration command for the applicable
interface. For details, see 14.2.4 Configuration of a port channel interface in the
Configuration Guide Vol. 1.
4. If you want to delete this command, do so after executing the
shutdown command
for the applicable interface.
5. Deleting this command does not delete the
port-channel configuration (deleting all
ports in a channel group does not delete the
port-channel configuration). When
deleting a channel group, you must delete the
port-channel configuration
manually.
Related commands
interface fastethernet
interface gigabitethernet