Specifications

channel-group max-active-port
107
channel-group max-active-port
Sets the maximum number of ports actually used in a channel group for link aggregation.
Syntax
To set or change information:
channel-group max-active-port <Number> [no-link-down]
To delete information:
no channel-group max-active-port
Input mode
(config-if)
Parameters
<Number> [no-link-down]
Sets the maximum number of ports actually used in a channel group for link
aggregation. If the number of ports that is actually used in a channel group exceeds
the value set by this command, use only the number of ports that is specified and
apply the standby link functionality to the rest of the ports. If you use the standby link
functionality in link-not-down mode, set the
no-link-down command. If you do not
do so, the standby link switches to the link-down stats. The criteria for selecting
which links are standby links are as follows:
 Select ports that have been assigned lower priority by using the
lacp
port-priority command.
 If the priority is the same, select a port with a larger interface port number.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 8
Default behavior
The maximum number is 8.
Impact on communication
The ports that are in use might be changed by the standby link functionality, and
communication might stop temporarily.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. Use this command in static link aggregation mode.
2. If you set the
max-active-port command, match its settings to the settings of the
max-active-port and lacp port-priority commands on the destination device.
3. To change link-down or no-link-down for the standby link mode, first delete the
parameter, and then set it again. To change the number of ports in link-not-down
mode, you must set the
no-link-down command.