Specifications

channel-group lacp system-priority
106
channel-group lacp system-priority
Sets the LACP system priority of a channel group for link aggregation.
Syntax
To set or change information:
channel-group lacp system-priority <Priority>
To delete information:
no channel-group lacp system-priority
Input mode
(config-if)
Parameters
<Priority>
Sets the LACP system priority. The lower the value, the higher the priority.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 65535
Default behavior
The setting of the lacp system-priority command is used.
Impact on communication
If a priority is set for the operating channel group, the channel group goes down, and then
restarts.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. This command is effective only when LACP-based link aggregation is used.
2. If the LACP system priority is changed, the status of all ports registered for the
channel group changes to
Blocking (communication interrupted).
Related commands
interface port-channel