Specifications

media-type [AX1250S] [AX1240S]
89
media-type [AX1250S] [AX1240S]
Selects the type of port to be used as a port on which
10BASE-T/100BASE-TX/1000BASE-T (RJ45) and 100BASE-FX/1000BASE-X (SFP) can
be switched.
Syntax
To set or change information:
media-type {rj45 | sfp | auto}
To delete information:
no media-type
Input mode
(config-if)
Parameters
media-type {rj45 | sfp | auto}
Selects the type of port to be used as a port on which
10BASE-T/100BASE-TX/1000BASE-T (RJ45) and 100BASE-FX/1000BASE-X
(SFP) can be switched.
rj45
An RJ45 port is used.
sfp
An SFP port is used.
auto
A port is automatically selected.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
rj45, sfp, and auto
Default behavior
auto (automatic selection) is set. The port operates as an sfp port when link-up occurs in
1000BASE-X.
Impact on communication
If the command is set for the line in use, the line goes down, but the line restarts on the
specified port.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. This command cannot be set for non-gigabit interfaces.
2. If
media-type is changed, the settings of the following commands return to the
default state:
duplex, mdix auto, and speed