Specifications

mdix auto
88
mdix auto
Sets the MDI functionality of the port to be used. When no mdix auto is specified, the
automatic MDIX functionality is disabled and the port is fixed to MDI-X.
Syntax
To set information:
no mdix auto
To delete information:
mdix auto
Input mode
(config-if)
Parameters
None
Default behavior
During auto-negotiation, MDI and MDI-X are switched automatically.
Impact on communication
If this command is set for the port in use, the port goes down and communication stops
temporarily. Thereafter, the port restarts.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. This command is enabled during auto-negotiation.
2. This command is invalid for 100BASE-FX/1000BASE-X.
3. If
media-type is sfp, this command is not valid. [AX1250S] [AX1240S]
4. If
media-type is changed, the command settings return to the default state.
[AX1250S] [AX1240S]
5. If
media-type auto is set, this command cannot be set. Use the default value.
[AX1250S] [AX1240S]
Related commands
media-type