Specifications

link debounce
86
link debounce
Sets the link-down detection time after a link failure is detected until the actual link-down
occurs. When a large value is set for this command, temporary link-downs will not be
detected so the link will be prevented from becoming unstable.
Syntax
To set or change information:
link debounce [time <Milli seconds>]
To delete information:
no link debounce
Input mode
(config-if)
Parameters
time <Milli seconds>
Sets the debounce timer value in milliseconds.
1. Default value when this parameter is omitted:
3000 milliseconds
2. Range of values:
Multiples of 100 from 0 to 10000 in milliseconds
Default behavior
2000 milliseconds is set.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If the link is stable even when a link-down detection timer is not set, you do not need
to set one.
2. If a value smaller than the default value (2000 milliseconds) is set for 10BASE-T,
100BASE-TX, or 1000BASE-T, the link might become unstable.
Related commands
None