Specifications

flowcontrol
83
2. Range of values:
receive desired, receive on, receive off
Default behavior
Behavior varies depending on the line type.
 For 10BASE-T, 100BASE-TX, or 1000BASE-T:
Receive operation is
off but send operation is desired.
 For 1000BASE-X:
Receive operation is
off but send operation is desired.
For 100BASE-FX [AX1250S]
Receive operation is
off but send operation is on.
Impact on communication
If this command is set for the port in use, the port goes down and communication stops
temporarily. Thereafter, the port restarts.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If either flowcontrol send or receive is set to on, both are set to on.
2. If
desired is set and auto-negotiation is set, operation is determined based on
negotiation. For any setting other than auto-negotiation,
flowcontrol is fixed to on.
3. For 100BASE-FX, no specific operation is performed when auto-negotiation is set
because auto-negotiation is not supported. [AX1250S]
Related commands
None