Specifications

duplex
80
duplex
Sets the duplex mode of a port.
Syntax
To set or change information:
duplex {half | full |auto}
To delete information:
no duplex
Input mode
(config-if)
Parameters
{half | full |auto}
Sets the connection mode of a port to half duplex (fixed), full-duplex (fixed), or
auto-negotiation.
The following table shows the combinations of line type and parameters that can be set.
auto is selected if a non-specifiable parameter is specified.
Table 8-1 Parameters that can be set
Line type Parameters that can be set
10BASE-T/
100BASE-TX
auto (when speed auto, auto 10, auto 100, or auto 10 100 is set)
half (when speed 10 or speed 100 is set)
full (when speed 10 or speed 100 is set)
10BASE-T/
100BASE-TX/
1000BASE-T
auto (when speed auto, auto 10, auto 100, auto 1000, auto 10 100, or auto 10 100
1000 is set)
half (when speed 10 or speed 100 is set)
full (when speed 10 or speed 100 is set)
100BASE-FX
[AX1250S]
full (when speed 100 is set)
1000BASE-X auto (when speed auto or auto 1000 is set)
full (when speed 1000 is set)
half
Sets the port to half duplex (fixed) mode.
full
Sets the port to full duplex (fixed) mode.
auto
Determines the duplex mode by auto-negotiation.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
half, full, auto