Specifications

bandwidth
78
bandwidth
Assigns the bandwidth of a line. This setting is used for calculating the line usage rate on a
network monitoring device.
Syntax
To set or change information:
bandwidth <kbit/s>
To delete information:
no bandwidth
Input mode
(config-if)
Parameters
<kbit/s>
Assigns the line bandwidth in kbit/s.
This setting is used for the
ifSpeed/ifHighSpeed (SNMP MIB) value of the
applicable line, and has no impact on communication.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
1 to 100000 (kbit/s for
interface fastethernet) [AX1250S] and [AX1240S]
1 to 1000000 (kbit/s for
interface gigabitethernet)
Do not specify a value that exceeds the line speed of the applicable line.
Default behavior
The line speed of the applicable line is the bandwidth.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
None